Ross-on-Wye, an area located in South Hertfordshire and close to the Monmouthshire border in Wales, is known as the “birthplace of the British tourist industry” due to the Wye Valley’s picturesque river scenery, landscapes, and castles and abbeys. It is also known for the famous Ross and Monmouth Railway, which opened in 1873 and closed in 1959, and ran through the valley.
I visited an old cottage in the area to assist a customer with restoring a Slate tiled kitchen floor. Slate tiles are particularly popular because of their versatility and durability, and truly they can be an asset to any property if the sealer is maintained correctly. Slate tiles need to be sealed to prevent dirt penetrating the pores of the stone as ingrained dirt is difficult to remove and causes the stone to lose its appearance. In this case the floor had been laid around five years earlier and the sealer had worn off in places and was wearing very thin in others. As you would expect dirt had now become ingrained in the tile and the grout had also become stained in places. Overall this problem had left the floor looking very dull and unappealing, as you can see from the photograph below.
Cleaning a Dull Slate Tiled Floor
To begin the restoration, I applied Tile Doctor Remove and Go liberally across the floor to strip away any remaining old sealer that was likely to be ineffectual and not preventing dirt from becoming ingrained in the stone. Next, I applied our strong alkaline cleaner, known as Tile Doctor Pro Clean to tackle that ingrained dirt. This was left to dwell on the floor and then agitated using a 17-inch rotary machine fitted with a black scrubbing pad.
After cleaning the floor, I rinsed the tiles thoroughly with water and used a wet vacuum to clear the area of the resulting slurry. Following this I concentrated on cleaning the grout lines using Pro Clean in combination with a wire brush, before leaving the floor to dry out completely for the next couple of days.
Sealing a Slate Tiled Floor
Later in the week, I returned to the property to seal the floor. Before doing so, however, I needed to test the floor for damp issues, especially since this was an old property and was unlikely to have a damp proof membrane installed. Running these damp tests are very important because excess moisture can cloud the sealer and damage its performance.
Thankfully, there proved to be no issues, and the floor was fine to seal. I did this using eight coats of Tile Doctor Seal and Go, which is a water based product (so no smell) that provides a durable, satin finish, and is recommended for use on a variety of tiles, including Quarry, Victorian, Sandstone and Terracotta.
As you can see from the photo above, the restoration was transformative and really restored the lustre to this Slate tiled floor. Another satisfied customer!
Source: Slate Tile Cleaning and Restoration in the Monmouthshire